RemovALL™ 820 is a water-based rust removing compound specifically designed to provide a clean, rust-free surface prior to re-coating. Available as a gel RemovALL™ 820 can remove heavy rust and prevent re-rusting for extended periods of time.

Specs - 820 RUST REMOVER & INHIBITOR

Features & Benefits

• Water-based
• Fully biodegradable
• Non flammable
• Contains no TAPs or HAPs (Toxic / Hazardous Air Pollutants)
• Easy clean up with running water
• Low VOCs
• Non-ozone-depleting
• As quick as conventional products
• Not regulated by authorities for storage

RemovALL™ 820 effectively removes all types of rust, whether light surface rust or deep seated blooms.

The end results produced with RemovALL™ are the same as those achieved by the harsh and dangerous chemicals presently used by industry.

The residue is easily removed by water rinsing and the surface is ready for a new coating. New coatings exhibited no reduction of adhesion under standard adhesion pull tests.

If allowed to air dry, the product will protect the surface from re-rusting for extended periods of time.

• Mild odour
• No corrosive fumes

Cost effective because:

Reduces man hours and effort required to complete a project re-coating.

TYPICAL USES

These products are suitable for treating vertical and horizontal surfaces.

Some applications include:

• Automobile parts
• Ships and boats
• Bridges and structural steel
• Residential railings, fences and furniture
• Aluminum brightening, i.e. boat masts

FOR VERTICAL and OVERHEAD SURFACES

Use RemovALL™ 820 - a gel that can be applied by brush, roller or spray equipment.

FOR HORIZONTAL SURFACES, SMALL PARTS or TOPICAL APPLICATIONS

Use RemovALL™ 820 to brush on.

OPTIMUM TEMPERATURE

Ambient and surface temperatures should be in the range of 20 to 32°C (68 to 89°F). The product performs effectively at lower temperatures, but the dwell time increases.

PREPARATION

Ensure that all areas not to be cleaned are suitably protected.

The product should not be diluted and does not need any mixing before application. Do not pre-wash the surface to be cleaned before application of RemovALL™.

TEST AREA

Always prepare a test area prior to full application. This will indicate the time required for project completion and suitability of product for the substrate.

APPLICATION PROCEDURE

Apply a thin layer of RemovALL™ 820 by brush, roller or a rag to fully cover the rusted surface.

A brush or a roller can be utilized for application over small areas.

Larger areas require a small hand pump, weed sprayer or conventional spray equipment capable of producing a fine atomized spray.

DWELL TIME

The time required to remove the rust depends on the type of rust and depth of penetration. Most rust will be cleaned within 10 to 15 minutes.

Rinse or wipe the product off as soon as an adequate cleaning has been achieved.

COVERAGE

Depending on the substrate, the coverage rate for RemovALL™ 820 normally falls between 100 to 250 sq.ft./US Gal. (2.5 to 6 sq.m/L).

REMOVAL AND CLEAN UP

If rust removal is the objective, removal can be accomplished by washing with running tap water at normal pressure.

If rust inhibition is desired, the residue should be allowed to air dry or wiped off with a cotton cloth. If the product is washed off, the substrate will be suceptible to immediate flash rusting again.

RE-COATING

As with any cleaning compound, it is advisable to check the pH of the steel before re-coating to ensure that it is compatible with the new coating system to be applied.

SAFETY PRECAUTIONS

Proper safety procedures should be followed at all times while handling the product.

Refer to the Material Safety Data Sheet for important health and safety information before use.